As frames get ever lighter, there’s increasingly less material with which to marry together all the different parts that combine to make up our bicycles. This has resulted in the disappearance of many of the threads, nuts and bolts that previously held them together. Instead, with components now manufactured to infinitesimally tight tolerances, many parts can simply be pushed together, streamlining assembly and allowing manufacturers to whittle away ever more weight.
Consequently, a host of new pressfit standards has sprung into existence. The idea of using a mechanical press to squish components into your delicate and expensive carbon frame can be somewhat anxiety-inducing for the amateur mechanic, but with the right tools and a little patience anyone can get to grips with pressfit standards. Just follow Chuck’s simple guide:
Time taken: 30 minutes Money saved: £15
Tools required:
- Bottom Bracket
- Bottom bracket bearing press
- 10mm Allen key
- Isopropyl alcohol
- Clean rags
Get set
Image 2 of 9
Here’s what a pressfit bottom bracket shell looks like – no screw threads, just a smooth internal surface. You’ll need to carefully tap out the old bearings, either with a bearing removal tool like Park Tool’s BBT-90.3 or with a bearing drift set.
Clean and prep
Image 3 of 9
Clean the inside of the BB shell with alcohol and a fresh rag. For an aluminium frame, a light coating of grease can prevent creaking. Most manufacturers advise not to use grease on a carbon frame but it’s unlikely to cause problems.
Load up the cartridge
Image 4 of 9
Pressfit bottom bracket cartridges normally consist of two plastic outers housing the bearings, joined with a sleeve – leave this attached to the drive-side. There are many types of pressfit BB but the principles for their installation are similar.
Pop it onto the press
Image 5 of 9
Having the right tool will make life much easier to fit your bearings, as it’s extremely important to apply the pressure evenly. It’s also crucial that the press contacts the outer housing and not the bearing itself, as this will damage it.
Chuck’s tip: ‘I used Park Tool’s BBP-1 bearing press set (£180, above) to whack in the bearings. But if you’re on a budget the TL-BB12 (£50) is a superb alternative.’ Get both tools at madison.co.uk.
Get set
Image 6 of 9
Fit the correct adaptor to the press and load the drive-side BB cup (the one with the sleeve attached). Gently push the whole assembly into the frame. Pair up the second adaptor and bearing and and push both onto the opposite side.
Increase the tension
Image 7 of 9
Ensure that the handle of the press is wound far enough out that you’ll be able to sufficiently tighten it. Once this is done, push it as far as possible into the frame and slot the removable stop into the appropriate groove on the back of the press.
Apply some pressure
Image 8 of 9
Check everything is correctly aligned and fitting squarely. Tighten by hand and check again. Fit a 10mm Allen key into the back of the press (to stop it spinning) and tighten the handle. Once the cups are seated, give a slight twist and you’re done.
Finishing up
Image 9 of 9
Fitting pressfit BBs doesn’t require much force, so be careful not to overdo it. Slightly unscrew the press, pop out the stop and remove the whole assembly. Give everything a quick wipe down. Congratulations, you’ve mastered pressfit installation!
